- Categories：Industrial chiller series
1, the use of imported high quality new European and American design compressor and the Italian factory pump Italy, particularly quiet, energy-saving and durable.
2, equipped with sophisticated electronic temperature controller, can accurately control the water temperature at +3 ℃ to +50 ℃.
3, a unique new design of the condenser and radiator, heat exchanger performance is excellent.
4, with stainless steel open tank, easy to clean and repair.
5, the machine is equipped with current overload protection, high and low voltage and electronic time delay and other safety devices
6, when a fault occurs, at any time issued a warning and display the cause of the malfunction.
Second, the configuration
1. Compressors: 2HP and 2HP The following 220V single-phase Panasonic licensing compressors; 6HP and 6HP or less (single-headed or double-headed or multi-head or more) using the United States Taikang or the United States Gu Lun compressor; 8HP single head Japan's Mitsubishi Compressor; 10HP and above 10HP Mitsubishi Heavy Industries compressor.
2. Condenser: Shell and tube condenser (imported high-efficiency threaded brass) casing.
3. Evaporator: 15HP and 15HP the following coil (brass imported from Taiwan high purity steel, around 16 laps); 15HP (excluding 15HP) shell and tube evaporator (Note: If the use of enclosed water tank, it is recommended Using shell evaporator)
4. Pump: Taiwan's source legislation licensing
5. Drying filter: US ALCO
6. Temperature control table: Itini brand Italian made
7. Appliances: Taiwan Shilin brand or Germany Schneider
8. High and low pressure table: Taiwan jiver
9. Fault display panel: single chip
10. Sheet metal: using 2mm thick A3 steel? Wind board 1.2mm
11. Paint: Car paint
12. Management: All pipes are brass and welded seamlessly
Note: The above configuration uniform factory standard machine configuration, if there are special requirements made according to special requirements!
Fourth, the notes
1 cooling capacity is based on: chilled water inlet and outlet temperature 12 ℃ / 7 ℃, cooling water temperature 30 ℃ / 35 ℃
2. Scope of work: Chilled water temperature range: 5 ℃ to 35 ℃; Chilled water temperature difference: 3 ℃ to 8 ℃. The condensing temperature is not higher than 35 ℃ environment * If the above parameters or dimensions are subject to change without notice *