1, plastic grinder and power unit to be installed firmly. If the plastic crusher needs to be fixed for a long period of time, it should be fixed on the cement foundation. If plastic crusher is needed to flow the operation, the unit should be installed on the base made of angle iron and the power machine (diesel engine or motor) and plastic Crusher pulley groove in the same plane of rotation. 2, after the installation of plastic grinder to check the fastening of the Ministry of fasteners, if loose to be given to tighten. At the same time to check the tightness of the belt is appropriate.
3, Before starting the plastic crusher, first turn the rotor by hand to check whether the claw, hammer and rotor are flexible and reliable, whether there is any collision phenomenon in the crushing chamber, whether the rotation direction of the rotor is in the same direction as the machine arrow, Plastic crusher lubrication is good.
4, do not replace the pulley, in case the speed is too high to cause explosion in the crushing chamber, or speed is too low affect the work efficiency of the crusher.
5, after the start of plastic shredder should keep its idling 2 ~ 3min, no abnormal phenomenon before feeding work.
6, work should pay attention to the operation of the plastic grinder at any time, first of all, feeding should be uniform, to prevent clogging debris room; Second, do not overload work for a long time. If you find a vibration, noise, bearings and the body temperature is too high, the phenomenon of jetting out, etc., should immediately stop checking, troubleshooting can continue to work.